User Manual

Enter and confirm your Wi-Fi network password,

then tap the Next button and tap Yes on the

confirmation popup.

NOTE

• Your Wi-Fi network password is case sensitive,

so enter it exactly the same as it was created

or as found on your Wi-Fi router/access point.

• Toggle

to make sure that you have entered

your Wi-Fi network password correctly.

Check if the LED indicator of your camera is

blinking blue slowly as shown. If so, your camera is

already in pairing mode (i.e., the camera's hotspot

is activated temporarily) and ready to pair.

Tap the Yes button.

NOTE

If your camera is not in pairing mode

Press and hold the Reset button (as shown below)

on the back of your camera for 5 seconds until

the LED indicator starts blinking blue rapidly, and

wait for about 30 seconds. When the LED indicator

starts blinking blue slowly, your camera is in

pairing mode.

(Continued on the next page)

Location of Reset button

Pairing Devices - Alert Indoor Camera