Use and Care Manual

Enter and confirm your Wi-Fi network password,

and then tap the Next button.

NOTE

• Your Wi-Fi network password is case sensitive,

so enter it exactly the same as it was created

or as found on your Wi-Fi router/access point.

• Toggle

to make sure that you have entered

your Wi-Fi network password correctly.

Check if the LED indicator of your camera is

blinking blue slowly as shown. If so, your camera is

already in pairing mode (i.e., the camera's hotspot

is activated temporarily) and ready to pair. Tap the

Next button.

NOTE

If your camera is not in pairing mode

Press and hold the Reset button (as shown below)

on the back of your camera for 5 seconds until the

LED indicator starts blinking blue rapidly, and wait

for about 30 seconds. When the LED indicator starts

blinking blue slowly, your camera is in pairing mode.

(Continued on the next page)

Location of Reset button

Pairing Devices - Alert Indoor Camera