User Manual

OPERATING BASICS

Low battery warning

Your devices will let you know when batteries are running low on

power.

• Install new batteries immediately for the Indoor Alarm Receiver

when all four LED indicators start blinking at the same time.

• Install new batteries immediately for the Gate Sensor when the

status LED starts blinking continuously.

Re-pairing your Gate Sensor

The Gate Sensor and Indoor Alarm Receiver in your kit have been

factory paired so all you have to do is put batteries in and your devices

are ready to use. If for some reason pairing is lost or you just want

the Gate Sensor paired to another channel for a different alarm (each

channel has a distinct sound), here's how to do it:

1. Make sure the sensor switch and magnet is in a "closed" position

(if mounted, the gate or door should be closed).

2. Press and hold the Reset button on the back of the Indoor Alarm

Receiver until all the LED indicators light up. This resets the

receiver.

3. Decide which channel (1, 2 or 3) you want to assign the Gate

Sensor to (refer to the table below for the alert sound that is

emitted by each sensor channel), and then press and hold the

desired Sensor Channel button on the back of the Indoor Alarm

Receiver until the LED indicator for that channel lights up.

Sensor Channel Alert Sound

1 Warning alarm tone

2 Klaxon (horn) alarm tone

3 Pleasant electronic buzzer tone

4. Within 10 seconds, trigger the Gate Sensor by separating the

sensor switch and magnet (if mounted, open the gate or door).

The Indoor Alarm Receiver sounds the channel alarm and flashes

the channel LED to confirm successful pairing.