Specifications

101010
Recording Modes
The Action Camera has two modes: Video Mode and Photo Mode.
Video Mode allows you to shoot moving
videos, which are saved to the microSD
card as .AVI fi les. Whilst in Video Mode,
the BLUE and ORANGE lights will stay
ON.
In Photo Mode the Action Camera will
take single still images, which are saved
to the microSD card as .JPG fi les. Whilst
in Photo Mode, the BLUE light only will
be ON.
Selecting your Mode:
After turning the Action Camera on:
Wait until the BLUE and ORANGE lights are both ON. This indicates that you 1.
are in Video Mode.
To change to Photo Mode, press and hold the Rec/Pause button for three 2.
seconds.
The ORANGE light will go out, and the BLUE light will stay on. This indicates 3.
that you are in Photo Mode.
To change back to Video Mode, press and hold the Rec/Pause button for 4.
three seconds. The ORANGE light will come back on, indicating the mode has
changed back to Video Mode.
Each time you turn on the 5. Action Camera, it will automatically enter Video
Mode, regardless of the mode it was in when turned off.
IMPORTANT:
Do NOT turn the Action Camera OFF whilst you are recording video or
capturing a still image (basically, any time that the GREEN light is ON).
If the Action Camera is turned off whilst writing a fi le to the microSD card then the
fi le will not be saved properly. In some cases, this can corrupt the fi le structure of
the microSD card, effectively erasing other recordings. Always use the Rec/Pause
button to stop recording before turning the Action Camera off!
Video Mode
Photo Mode
77
...on a Windshield/Window
To record either what’s going on inside or outside of the car, you can mount the
Action Camera to the windshield or to a window using the included stand with
suction-grip.
To mount the suction-grip stand:
Find a fl at, glass surface1. to mount the suction-grip on.
Clean the glass using a glass cleaner2. or cleaning alcohol, and a soft, lint
free cloth. Clean suction cup with same method. Allow both to dry completely.
The cleaner both surfaces are, the better the suction cup will stick.
Make sure that the lever on the suction-grip is released (aimed UP).3.
Press4. the suction cup fi rmly against the surface you wish to stick it to.
Press the 5. lever down to lock into position.
Check the integrity6. of the suction-grip’s hold by gently pulling and tapping
the stand.
If it is secure, mount the 7. Action Camera into position, and aim it as required.
To release the suction-grip:
Remove the 1. Action Camera from the stand.
Move the lever to the released (UP) position.2.
Pull the small tab3. on the side of the suction-grip.
Tips and Tricks:
For the safety of your • Action Camera, we strongly suggest mounting the
suction-grip stand inside the vehicle only! If it does come unstuck, you don’t
want to run over it with your car (it’s tough, but not that tough).
You can use the same mechanism to attach the suction-grip stand to any • fl at,
clean, nonporous surface. However, exercise caution: many surfaces don’t
offer as reliable a surface as glass to mount the suction-grip to.
Suction Grip
Released
Suction Grip
Attached