User's Manual

FCC statement
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
 Ｒｅｏｒｉ ｅｎｔ ｏｒ ｒｅｌ ｏｃａｔ ｅ ｔ ｈｅ ｒｅｃｅｉ ｖｉ ｎｇ ａｎｔ ｅｎｎａ．
 Ｉ ｎｃｒｅａｓｅ ｔ ｈｅ ｓｅｐａｒａｔ ｉ ｏｎ ｂｅｔ ｗｅｅｎ ｔ ｈｅ ｅｑｕｉ ｐｍｅｎｔ ａｎｄ ｒｅｃｅｉ ｖｅｒ．
 Ｃｏｎｎｅｃｔ ｔ ｈｅ ｅｑｕｉ ｐｍｅｎｔ ｉ ｎｔ ｏ ａｎ ｏｕｔ ｌ ｅｔ ｏｎ ａ ｃｉ ｒｃｕｉ ｔ ｄｉ ｆ ｆ ｅｒｅｎｔ ｆ ｒｏｍ
ｔ ｈａｔ ｔ ｏ ｗｈｉ ｃｈ ｔ ｈｅ ｒｅｃｅｉ ｖｅｒ ｉ ｓ ｃｏｎｎｅｃｔ ｅｄ．
 Ｃｏｎｓｕｌ ｔ ｔ ｈｅ ｄｅａｌ ｅｒ ｏｒ ａｎ ｅｘｐｅｒｉ ｅｎｃｅｄ ｒａｄｉ ｏ／ ＴＶ ｔ ｅｃｈｎｉ ｃｉ ａｎ ｆ ｏｒ ｈｅｌ ｐ．
＂ＦＣＣ ＲＦ Ｒａｄｉ ａｔ ｉ ｏｎ Ｅｘｐｏｓｕｒｅ Ｓｔ ａｔ ｅｍｅｎｔ Ｃａｕｔ ｉ ｏｎ： Ｔｏ ｍａｉ ｎｔ ａｉ ｎ
ｃｏｍｐｌ ｉ ａｎｃｅ ｗｉ ｔ ｈ ｔ ｈｅ ＦＣＣ＇ ｓ ＲＦ ｅｘｐｏｓｕｒｅ ｇｕｉ ｄｅｌ ｉ ｎｅｓ， ｐｌ ａｃｅ ｔ ｈｅ ｐｒｏｄｕｃｔ
ａｔ ｌ ｅａｓｔ ２０ｃｍ ｆ ｒｏｍ ｎｅａｒｂｙ ｐｅｒｓｏｎｓ． ＂
To comply with FCC’s RF radiation exposure limits for general population/uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be collocated or operating in
conjunction with any other antenna or transmitter
Shielded cables must be used with this unit to ensure compliance with the Class
B FCC limits.