User's Manual

Intern et
Ethern et
4
3
2
WPS
The Ethernet cable is only required for initial setup. Configure the Smart Hub to
connect to your Wi-Fi network directly during registration then go wireless.
Connect Ethernet Cable Connect Power Adapter Find MAC ID Register Smart Hub
Broadband Internet router
Ethernet cable
Power adapter
Ethernet port
Power port
Connect the Smart Hub directly to your broadband router with the
included Ethernet cable.
Plug the included power adapter into a power outlet and connect
it to the Smart Hub
There is an information label located on the bottom of the Smart Hub
containing all the little details about your hub including it’s MAC ID. You
will need the MAC ID during registration, so have it ready on hand. It
looks something like the example below.
MAC ID: __ __ – __ __ – __ __ – __ __ – __ __ – __ __
1 2 3 4
INP UT:5V 2A
This d evice c ompli es with P art 15 of t he FCC Ru les. Op erati on is sub ject to t he
fol lowin g two con ditio ns: (1) t his dev ice may n ot caus e harmf ul inte rfere nce, an d
(2) t his dev ice mus t accep t any int erfer ence re ceive d, incl uding i nterf erenc e that
may c ause un desir ed oper ation
MAC I D:XX- XX-XX -XX-X
X-X X
FCC I D:VMI SWO-H UB01K
S/N o:XXX XXMMY YXXXX X
Mod el:SW O-HUB 01K
IC: XX123A -B12 34 56 78 90
Eac h USB:5 V 500mA
Designed in Australia
Made in Ch ina
This device complies with Part 15 of the FCC Rules. Op
e
following two conditions: (1) this device may not cause harm
MAC ID:XX-XX-XX-XX-XX-XX
S/No:XXXXXMMYYXXXXX
IC
:
XX123A
-
B1234567890
Each USB:5V 500mA
MAC ID:AB-CD-E -1 2 -3 4 -5 6F
Jot it down here!
Creating a SwannOne Account
Before you can register the Smart Hub, you will need to create a
SwannOne account. Your SwannOne account is what you use to control
and manage all your SwannOne devices and services from anywhere.
To sign up for a free account, go to home.swannone.com from your
PC, Mac, smartphone or tablet.
Installing the Smart Hub
Log in to your new SwannOne account at
home.swannone.com and then follow
the on-screen instructions to add the
Smart Hub to your SwannOne account.
If the Smart Hub is not connecting as expected, try performing a hard reset by using
a straightened paperclip to depress the Reset button while holding the WPS button
until the status light on the front of the Smart Hub goes off.