Instruction Manual

9
EN
MOUNTING THE DEVICES
To mount the Alert Sensor:
• Wall mounting using screws
Doorbell
The Doorbell can be mounted to the surface using the supplied mounting plate and
adhesive tape. Avoid mounting on metal surfaces as this can reduce the operating range.
1. Make sure the surface is dry, smooth and free of dust and other substances that
could affect adhesion. Clean the surface with an alcohol/
cleaning wipe, and let dry.
2. Peel off the adhesive tape liner on the back of the Doorbell
mounting plate, and then press the mounting plate rmly to the
surface for 60 seconds to ensure solid adhesion.
3. Slide the Doorbell down onto the mounting plate until it clicks
into place.
A
B
1. Attach the mounting bracket to the
wall using two screws (supplied).
You may need to use wall anchors
depending on the surface.
2. Slide the Alert Sensor down onto the
mounting bracket until it is secured
in place. Then, adjust the angle of the
Alert Sensor accordingly to achieve
the best detection results.
1. Do not use on rough surfaces. Works best on at, smooth
surfaces. Clean the surface with an alcohol/cleaning wipe,
and let dry.
2. Attach the circular wall plate
A
to the mounting
bracket using two small screws (supplied).
3. Afx the double-sided tape
B
to the back of the
wall plate
A
, then press the mounting bracket
rmly to the wall for 60 seconds to ensure solid
adhesion.
4. Slide the Alert Sensor down onto the
mounting bracket until it is secured
in place. Then, adjust the angle of the
Alert Sensor accordingly to achieve
the best detection results.
• Wall mounting using adhesive tape