Installation Guide

Filler Boards
If an existing wall covering (i.e. tile) does not extend to a height
equal to the height of the panel, it will be necessary to install
a filler board to that height. The filler board must equal the
thickness of the existing wall covering (tile). Usually 1/4 inch
masonite, or similar material, is adequate. If desired, the filler
board can extend from the top edge of the tile to the ceiling.
Failure to use a filler board to properly install the panels could
result in water damage or other damage to floors, walls, or
other portions of your building or home.
A
B
New Construction Wallboard Installation
Note: If the high gloss wall panel kit is to be installed over an
existing wall surface, proceed to the next section.
1. Measure and cut out openings for the faucet(s), bathtub
spout, and/or shower head. Install 1/2 inch moisture-
resistant cement board or greenboard over back (1), front
(2), and rear (3) wall surfaces of the rough opening.
1
2
3
IMPORTANT NOTICE
To prevent possible water (wicking affect) damage to the wall,
install the wall board with a 1/2 inch gap above the bathtub or
shower floor side lip, the front edge of the bathtub or shower
floor, and the room floor.
1/2"
1/2"
1/2"
2. Apply a coat of water or oil-based primer/sealer to all
the surfaces of the cement board or greenboard (follow
the manufacturer’s instructions). Allow the primer to dry
thoroughly before applying any silicone sealant.
High Gloss Wall Kits
IMPORTANT NOTICE
Before beginning, refer to the General Information section for
important information on how to prepare the existing bathtub
or shower walls for installation.
Swan Corporation high gloss wall kits feature several distinct
designs, depending on kit style and the size of the bathtub or
shower enclosure.
The wall kits are divided into different styles: those with
separate corner panels and those with combined corner side
panels. The different installation procedures are covered in
the following sections. Refer to the Installation section that
matches the Swan Corporation product being installed.
Installation
IMPORTANT NOTICE
Before starting the installation, refer to the Kit Contents
section to verify the contents of the carton are correct. Also,
read, understand, and follow any NOTES listed for your model
Swan Corporation wall kit.
DO NOT nail wall panels to sub-walls. This will damage the
wall panels, could result in water damage or other damage to
floors, walls, or other portions of your building or home, and
will void the warranty.
Wall panels with a bullnose (curved) edge should be installed
with the bullnose edge toward the front edge of the bathtub or
shower floor.
For a professional looking installation, align the top edges of the
adjacent panels and line up any grout lines. If the bathtub or
shower floor has settled or is out of plumb, it may be necessary
to file or sand the bottom edge of the panels to achieve a good
fit across the top. Trial fit all panels before final installation.
If the existing bathtub or shower enclosure has a window, the
optional WTK-1 Window Trim Kit can be used to finish out the
installation and help protect the window from moisture damage.
Gaps between the bathtub or shower floor ledge and the
bottom edge of the wall panels must be caulked after the
temporary bracing is removed.
Installation Procedure
800-325-7008 7 Swan