Installation Guide

2. Extension panel (A) should be installed at the opposite
end of the shower, away from showerhead (C). This
allows installation of back panel (B) with the soap dish and
shampoo shelf closer to the showerhead.
B
C
A
C
B
A
3. If the back wall measurement is 47 to 51 inches, cut the
extension panel in half and install one half of the panel
overlapping each corner panel. The back panel will be
installed between the two panel halves.
4. Trial fit the cut extension panels and back panel. Make
sure there is at least 1 inch of panel overlap at each edge.
5. Refer back to Step 1 through Step 4 of the Back Panel
section for instructions on applying silicone sealant and
installing extension panels and back panel.
IMPORTANT NOTICE
Refer to the Temporary Bracing section for information on
bracing to hold the panels in place until the silicone sealant is
completely set (usually 24 hours). This will allow proper
curing of the silicone sealant.
6. Install temporary bracing to hold the wall panels in place
until the silicone sealant cures.
7. After the temporary bracing is removed, refer to the
Caulking section for information on applying color match
silicone sealant to joints and seams.
Wall Kits With Corner Side Panels -
RM-58, HA-58, SW-7032, and SW-NEO-DTF
HA-58 RM-58
SW-NEO-DTF
SW-7032
Corner-Side Panels
Many corner side panels are designed to fit a certain way.
Check for identification tags on the back of the panels. Molded
in shelves must be installed with the flat surface facing up.
Corner-side panels without tags or molded in features may be
interchangeable.
1. Select the corner side panel that will be cut for the
plumbing fixture outlets.
2. Measure the openings for faucet(s), bathtub spout, and/
or shower head. Measure the height up from the ledge of
the bathtub or shower floor ledge. Measure out from the
back wall
A
A
3. Use the measurements to make a cardboard template in
order to check for proper fit around the plumbing outlets.
Trial fit the cardboard template, and adjust as necessary.
4. Transfer the template measurements to the corner side
panel.
WARNING
Dust Hazard
When cutting or drilling the Swan Corporation
product, use a dust collection method which
prevents dust particles from going into the air. Always
work in a well-ventilated area. To keep the area well-
ventilated, open windows and use exhaust fans. Always
use an OSHA approved dust mask when cutting, drilling, or
sanding Swan Corporation products.
800-325-7008 13 Swan
Installation Procedure