Instructions / Assembly

5. SIDE PANELS
NOTE: Side panels “A” are inter-
changeable BUT the 2 Bull Nose
must face to the outside of the
shower for proper installation.
Measure location of plumbing out-
lets from a line straight up from
front edge of shower floor and
height above top ledge of the
shower floor. We suggest you
make a template from cardboard
to help position your side panel
over plumbing outlets.
Transfer measurements to panel
making sure (before you drill) that
you have selected the correct
panel.
6. Use a drill and hole cutting bit,
or a hole saw, to cut your holes
⁄Ω™ larger than the diameter of the
pipes. Drill or cut from the fin-
ished side of panel. For best
results, place a scrap of wood
beneath hole to be cut. This gives
you a clean opening. Trial fit
before proceeding.
7. Apply the adhesive as noted.
Globs of adhesive should be
“piled” approximately ⁄Ω™ high
and 1 in diameter. Add adhesive
around drilled holes.
Remove backing from factory
applied pressure sensitive tape.
2 Bull Nose—Must Face To
Outside of Shower
NOTE: Special attention should
be given to pressing the center
of the panels firmly against the
wall to insure adequate contact
of the tape and adhesive.
8. Carefully line up front edge of
panel with front edge of shower
floor and overlap corner panel.
8A. IMPORTANT
Grout lines and top edge of side
panel should be aligned with grout
lines and top edge of corner panels.
If floor has settled or is out of
plumb a gap between bottom edge
of wall and shower floor ledge
may exist. This gap can be filled
in with caulking (see CAULKING
below).
Press firmly starting from bottom
and continuing up to insure solid
wall contact.
Repeat steps #7 and #8 for other
side panel.
FORM #803-4-91-5M
CAULKING
Following instructions on the caulking tube…apply a bead of
caulk along the gap between bottom edge of Showerwal and
shower floor ledge. It is also suggested that a thin bead of
caulking be applied to overlap between back panel, side panels,
and corner panels. Caulking should also be applied along front
and top edges of wall installation.
Please allow unit to be installed 24 hours before using. This will
allow proper curing of adhesive and caulking material.
PRESSED FIBERGLASS PRODUCTS CARE
AND CLEANING
All Panels in this kit are made of fiberglass reinforced polyester.
Finish is stain and abrasion resistant, however, the finish
requires reasonable care.
Wash regularly with warm water, use soft cloth with mild liquid
detergent such as Handy Andy, Mr. Clean, or Lestoil.
Scouring pads made of nylon, saran, or polyethylene may be
used but NEVER USE ABRASIVE SCOURING POWDERS,
CLEANSERS OR PADS…THEY DULL FINISH.
CAUTION
Dry cleaning agents and solvents will damage the surface.
Burning cigarettes will damage and discolor surface.
NOTE: To promote contact until adhesive sets, it is suggested
that you use temporary bracing and allow adhesive to cure
overnight. Temporary bracing may be constructed and wedged
into position as illustrated by using lengths of 1 x 2s, 2 x 2s,
1x3s. Lumber should be cut as needed. To insure adhesion of
the panel corners to the installation surface, position the
temporary bracing as illustrated above.
POSITIVELY NO HAMMERING OR NAILING IS TO BE DONE.