Instructions / Assembly
STEP-BY-STEP INSTALLATION INSTRUCTIONS
MODEL TI-7236/BC-7236; TI-7248/BC-7248; TI-7260/BC-7260
FIBERGLASS SHOWERWAL
TOOLS REQUIRED TO INSTALL
The only tools needed are a saber saw or drill, ruler, caulking
gun, and whatever tools are needed to remove faucet handles.
Panels mount to the wall with supplied adhesive. Panels come
with factory applied pressure sensitive tape affixed permanently
to the outside edges.
DO NOT NAIL PANELS TO SUBWALLS
INSTALLATION PROCEDURE:
Allow panels to adjust to room temperature (65° to 90°) for at
least 6 hours.
Next, turn off hot and cold water supply, remove faucet
handles, escutcheons, and any fittings mounted to wall to be
covered including towel bars, soap dishes, etc.
Use hammer and chisel to remove objects cemented to walls.
Old ceramic tiles, if adhered solidly to walls may be covered
with this kit and need not be removed.
Loose tiles must be removed (sand sub walls smooth).
Front edge tiles may be reset for appearance only. Remove
soap film and dirt from wall surface using detergent. Wipe dry;
wall surface must be dry before panels can be applied.
Measure the width of the back wall. If it measures less than
30⁄Ω™ or more than 63‹Ω¢, you cannot use this unit. Likewise, if
your shower area is less than 31 deep or more than 36 deep
this unit is not suitable for your installation.
BE SURE TO READ THE ENTIRE INSTALLATION SHEET
BEFORE STARTING.
SIDE PANELS
The side panels are interchangeable from right to left.
However, for proper fit the 2 Bull Nose (see product drawing
on this page) must face to the outside of the shower.
CORNER PANELS
Sides of corner panels are different widths. One side is 5
wide, the other is 7 wide.
If shower is 34 or less deep the 7 side goes against the back
wall–figure #1. If side wall is over 34 the 5 side of the corner
panel goes against the back wall–figure #2. The location of the
7 corner dimension will affect the dimensional flexibility of
these units on the back wall. Measure your shower alcove
area before you start and consult the following chart for proper
corner panel location.
Corner panel with 7 dimension on BACK WALL (figure #1)
Side Panel Fits 31 to 34
Wall Area All Models
Back Panel TI-7236/BC-7236 TI-7248/BC-7248 TI-7260/BC-7260
Wall Area 29⁄Ω¢ to 39‹Ω¢ 41⁄Ω¢ to 51‹Ω¢ 53⁄Ω¢ to 63‹Ω¢
Corner panel with 5 dimension on BACK WALL (figure #2)
Side Panel Fits 31 to 36
Wall Area All Models
Back Panel TI-7236/BC-7236 TI-7248/BC-7248 TI-7260/BC-7260
Wall Area 29⁄Ω¢ to 35‹Ω¢ 41⁄Ω¢ to 47‹Ω¢ 53⁄Ω¢ to 59‹Ω¢
We recommend that whenever possible, position corner panel as in figure #1.
INCLUDED IN CARTON:
A
Two side panels
B Two corner panels
C One back panel with soap dish
D Adhesive:
Four tubes TI-7236/BC-7236
and TI-7248/BC-7248
Five tubes TI-7260/BC-7260
E One tube of color coordinated caulk