Instructions / Assembly

ManualsBrandsSwan ManualsBath36 in. x 64-3/4 in. x 71-5/8 in. Five Piece Easy Up Adhesive Shower Wall Kit in Bone

MODEL NO.

TI-7236/BC-7236

TI-7248/BC-7248

TI-7260/BC-7260

OWNER’S

MANUAL

CAUTION:

Read ALL instructions

carefully BEFORE

starting your installation.

Save this manual for

future reference

Installation procedure for

FIBERGLASS SHOWERWAL KIT

MODEL TI-7236/BC-7236

Areas 31 to 36 deep

Areas 29⁄Ω¢ to 39‹Ω¢ wide

MODEL TI-7248/BC-7248

Areas 31 to 36 deep

Areas 41⁄Ω¢ to 51‹Ω¢ wide

MODEL TI-7260/BC-7260

Areas 31 to 36 deep

Areas 53⁄Ω¢ to 63‹Ω¢ wide

INSTALLATION • CARE AND CLEANING • REPAIR PARTS

Summary of content (4 pages)

PAGE 1
MODEL NO. TI-7236/BC-7236 TI-7248/BC-7248 TI-7260/BC-7260 OWNER’S MANUAL Installation procedure for FIBERGLASS SHOWERWAL KIT MODEL TI-7236/BC-7236 Areas 31 to 36 deep Areas 29⁄Ω¢ to 39‹Ω¢ wide MODEL TI-7248/BC-7248 Areas 31 to 36 deep Areas 41⁄Ω¢ to 51‹Ω¢ wide MODEL TI-7260/BC-7260 Areas 31 to 36 deep Areas 53⁄Ω¢ to 63‹Ω¢ wide CAUTION: Read ALL instructions carefully BEFORE starting your installation.
PAGE 2
STEP-BY-STEP INSTALLATION INSTRUCTIONS MODEL TI-7236/BC-7236; TI-7248/BC-7248; TI-7260/BC-7260 FIBERGLASS SHOWERWAL INCLUDED IN CARTON: A Two side panels B Two corner panels C One back panel with soap dish D Adhesive: Four tubes TI-7236/BC-7236 and TI-7248/BC-7248 Five tubes TI-7260/BC-7260 E One tube of color coordinated caulk TOOLS REQUIRED TO INSTALL CORNER PANELS The only tools needed are a saber saw or drill, ruler, caulking gun, and whatever tools are needed to remove faucet handles.
PAGE 3
WALL SURFACE PREPARATION RECOMMENDATIONS FOR FIBERGLASS TUBWAL AND SHOWERWAL UNITS When installing over SHEETROCK/GREENBOARD/WOOD: A) Surface must be dry, smooth and free of any dust, soap scum or any other contaminants. Wipe wall surface with a damp cloth. B) For maximum adhesion, the area where the double-faced tape adheres to the wall surface should be sealed with a primer (Bin-Seal or all purpose enamel paint).
PAGE 4
5. SIDE PANELS NOTE: Side panels “A” are interchangeable BUT the 2 Bull Nose must face to the outside of the shower for proper installation. Measure location of plumbing outlets from a line straight up from front edge of shower floor and height above top ledge of the shower floor. We suggest you make a template from cardboard to help position your side panel over plumbing outlets. Transfer measurements to panel making sure (before you drill) that you have selected the correct panel. 6.