Instructions / Assembly

INSTALLATION
PROCEDURE
Allow panels to adjust to
room temperature (65° to
90°) for at least 6 hours.
Next, turn off hot and cold
water supply, remove fau-
cet handles, escutcheons,
filler spouts and any
fittings mounted to wall to
be covered including towel
bars, soap dishes, etc.
Use hammer and chisel to
remove objects cemented
to walls. Old ceramic tiles,
if adhered solidly to walls,
may be covered with this
kit and need not be
removed.
Loose ceramic tiles must
be removed (sand sub
walls smooth).
Front edge ceramic tiles
may be reset for ap-
pearance only. Remove
soap film and all dirt from
wall surface using deter-
gent. Wipe dry; wall sur-
face must be dry before
panels can be applied.
INCLUDED IN CARTON:
A
One left side panel with shampoo shelf
B Two corner panels
C One back panel with soap dish
D One right side panel with shampoo shelf
E One left side apron strip
F One right side apron strip
G Four tubes of adhesive
H One tube of color coordinated caulk
TOOLS REQUIRED TO INSTALL
The only tools needed are a saber saw or drill, ruler, caulking
gun, and whatever tools are needed to remove faucet
handles.
Panels mount to the wall with supplied adhesive. Panels
come with factory applied pressure sensitive tape affixed
permanently to the outside edges.
DO NOT NAIL PANELS TO SUBWALLS
Measure the length of the back wall. If it measures less than
53 or more than 60, you cannot use this unit. Likewise, if
your bathing unit is less than 29 deep or more than 32 deep
this unit is not suitable for your installation.
BE SURE TO READ THE ENTIRE INSTALLATION SHEET
BEFORE STARTING.
IMPORTANT!
FOR SHOWER DOOR INSTALLATION ONLY
The installation of a shower door with Model
TI-5/BC-5066 Tubwal Kit will require that the
following installation procedures be followed.
The side panels must
be installed even with the
front edge of the tub, and the apron strips
discarded. This will allow ample room for vertical
shower door extrusions to clear side panel
shampoo shelves.
1. CORNER PANELS
Select either panel for right or left
corner. Apply adhesive to back side
of the panel. A dot or “glob” of adhe-
sive should be applied as indicated
in illustration. Keep the adhesive at
least one inch from tape and panel
edges.
TRIAL FIT
BEFORE YOUR START
STEP-BY-STEP INSTALLATION INSTRUCTIONS
MODEL TI-5/BC5066
DESIGNED FOR TUB AREA 53 TO 60 WIDE AND 29 TO 32 DEEP
FILLER BOARD
Measure the height of your tile from the
tub ledge up; if tile is less than 59-5/8
then you must install a filler board. The
filler board must equal the same
thickness as the missing tile. Usually
1/4 masonite or similar material is
adequate.
For best results, run your filler board
from the tile ledge to the ceiling.
SEE BACK PAGE OF OWNER’S MANUAL
FOR INFORMATION ABOUT THE MODEL
TI-5/BC-5066 EXTENSION KIT.