Instructions / Assembly

ManualsBrandsSwan ManualsBath32 in. x 60 in. x 59-5/8 in. Five Piece Easy Up Adhesive Tub Wall in White

MODEL NO.

TI-5/BC-5066

OWNER’S

MANUAL

Installation procedures for

MODEL NO. TI-5/BC-5066

Designed for tub area 53 x 60 wide 29 x 32 deep

INSTALLATION • CARE AND CLEANING • REPAIR PARTS

Save this manual for

future reference

CAUTION:

Read ALL instructions

carefully BEFORE

starting your installation.

Summary of content (4 pages)

PAGE 1
MODEL NO. TI-5/BC-5066 OWNER’S MANUAL Installation procedures for MODEL NO. TI-5/BC-5066 Designed for tub area 53 x 60 wide 29 x 32 deep CAUTION: Read ALL instructions carefully BEFORE starting your installation.
PAGE 2
STEP-BY-STEP INSTALLATION INSTRUCTIONS MODEL TI-5/BC5066 DESIGNED FOR TUB AREA 53 TO 60 WIDE AND 29 TO 32 DEEP INCLUDED IN CARTON: A One left side panel with shampoo shelf B Two corner panels C One back panel with soap dish D One right side panel with shampoo shelf E One left side apron strip F One right side apron strip G Four tubes of adhesive H One tube of color coordinated caulk TOOLS REQUIRED TO INSTALL The only tools needed are a saber saw or drill, ruler, caulking gun, and whatever tools are need
PAGE 3
WALL SURFACE PREPARATION RECOMMENDATIONS FOR FIBERGLASS TUBWAL AND SHOWERWAL UNITS When installing over SHEETROCK/GREENBOARD/WOOD: A) Surface must be dry, smooth and free of any dust, soap scum or any other contaminants. Wipe wall surface with a damp cloth. B) For maximum adhesion, the area where the double-faced tape adheres to the wall surface should be sealed with a primer (Bin-Seal or all purpose enamel paint).
PAGE 4
6. SIDE PANELS NOTE: Side panels A and D are not interchangeable. Check backs for markings left and right (top). Measure location of plumbing outlets from a line straight up from front edge of apron strips (or tub, if strips are not used) and height above top ledge of the tub. We suggest you make a template from cardboard to help position your side panel over plumbing outlets. Transfer measurements to panel making sure (before you drill) that you have selected the correct panel. 7.