Installation Guide

plumping fixture outlets.
2. Measure the openings for faucet(s), bathtub spout, and/
or shower head. Measure the height up from the ledge of
the bathtub or shower floor ledge. Measure out from the
back wall.
A
A
3. Use the measurements to
make a cardboard template in
order to check for proper fit around the plumbing outlets.
Trial fit the cardboard template, and adjust as necessary.
4. Transfer the template measurements to the corner side
panel.
WARNING
Dust Hazard
When cutting or drilling the Swan Corporation product, use
a dust collection method which prevents dust particles
from going into the air. Always work in a well-ventilated
area. To keep the area well-ventilated, open windows and
use exhaust fans. Always use an OSHA approved dust
mask when cutting, drilling, or sanding Swan Corporation
products.
IMPORTANT NOTICE
Any cutout should have rounded corners (sharp corners can
promote stress cracks).
5. Cut clearance holes using a router, saber saw, or hole
saw. Drill or cut holes 1/2 inch larger than the diameter of
the plumbing outlets from the finished side of the panel.
For best results, when drilling, place a scrap of wood
beneath the hole to ensure a clean cut.
6. Trial fit the panel, and make any necessary adjustments.
Note: The corner side panel should not extend all the way to
the front edge of the bathtub.
WARNING
Fumes Hazard
The fumes from the silicone sealant and
solvents used by the installer can be harmful if
used in an unventilated room. Always work in a well-
ventilated area. To keep the area well-ventilated, open
windows and use exhaust fans. If adequate ventilation is not
achievable or practical, use respiratory protective equipment.
7. Clean the back of the panel with denatured alcohol.
IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from properly adhering to the wall.
8. Apply the silicone sealant in 1-1/4 inch diameter dots
every 8 to 10 inches over the back surface of the panel.
Follow the silicone manufacturer’s instructions and note all
ventilation and installation precautions.
9. Carefully position the corner side panel tight against the
corner and firmly press the surface of the panel against
the walls. The corner side panel should not extend all the
way to the front edge of the bathtub.
10. Apply hand pressure up and down and side-to-side,
making sure all areas are in firm contact with the wall. It
is important to apply hand pressure to the entire surface of
the panel to bond it to the wall surface.
800-325-7008 13 Swan
Installation Procedure