Instructions / Assembly

ManualsBrandsSwan ManualsBath30 in. x 60 in. x 57 in. Five Piece Easy Up Adhesive Tub Wall in White

INSTALLATION • CARE AND CLEANING • REPAIR PARTS

Installation procedures for

PRESSED FIBERGLASS TUBWAL KIT

Designed for areas 58ⴖ to 60ⴖ wide, 28ⴖ to 30ⴖ deep.

The Swan Corporation

MODEL NO.

TF-57

OWNER’S

MANUAL

CAUTION:

Read ALL instructions

carefully BEFORE

starting your installation.

Save this manual for

future reference

Summary of content (4 pages)

PAGE 1
MODEL NO. TF-57 The Swan Corporation Installation procedures for OWNER’S MANUAL PRESSED FIBERGLASS TUBWAL KIT Designed for areas 58ⴖ to 60ⴖ wide, 28ⴖ to 30ⴖ deep. CAUTION: Read ALL instructions carefully BEFORE starting your installation.
PAGE 2
STEP-BY-STEP INSTALLATION INSTRUCTIONS MODEL TF-57 DESIGNED FOR AREAS 58ⴖ TO 60ⴖ WIDE, 28ⴖ TO 30ⴖ DEEP INCLUDED IN CARTON: A One back panel B One fiberglass left corner panel C One fiberglass right corner panel D Two fiberglass side panels E Three tubes adhesive F One tube caulk G One roll pressure sensitive tape 28” 3” 17” 28” 57” FIBERGLASS LIMITED WARRANTY B A C F D E G IMPORTANT TOOLS REQUIRED TO INSTALL The only tools needed are: saber saw, drill, ruler, caulking gun, three tubes of adhesiv
PAGE 3
WALL SURFACE PREPARATION RECOMMENDATIONS FOR SWAN TUBWAL AND SHOWERWAL UNITS When installing over SHEETROCK/GREENBOARD/WOOD: A) Surface must be dry, smooth and free of any dust, soap scum or any other contaminants. Wipe wall surface with a damp cloth. B) For maximum adhesion, the area where the double-faced tape adheres to the wall surface should be sealed with a primer (Bin-Seal or all purpose enamel paint).
PAGE 4
5 5. Apply adhesive to back of panels with the application pattern indicated at left. The measurements given are approximate. However, adhesive must not come into contact with the tape. Peel and remove backing from tape prior to application. Use 2/3 tube of glue for each side and back panel. 6. Grasp side panel firmly by the edges, carefully position overlapping corner panel and press firmly into wall. A 1ⴖ overlap is recommended.