Installation Guide

4. Insert (wedge) blocks or cross braces between the front
to rear panel braces and the back panel braces. These
blocks or braces must apply pressure to the back panel to
hold it in place.
For corner shower wall installation use the following illustrated
bracing design.
ATTENTION: Additional bracing may be required if the
Swanstone brand panel does not make full contact to the
wall it is adhered to.
These boards need to
be attached to the two
outlying boards
Attach this
board to
the wall
Attach this
board to
the wall
5. Remove the braces after 24 hours.
Caulking
Note: Install any optional accessories and/or optional window
trim kit before caulking edges and seams.
1. Apply a bead of color match silicone sealant to the joint
where the bottom of the wall panels meet the shower or
bathtub ledge.
2. Apply a bead of color match silicone sealant to the top
edge of the entire unit.
3. Apply a continuous bead of color match silicone sealant
along all vertical and horizontal seams at side, back,
and optional accessories and/or window trim kit joints (if
installed).
IMPORTANT NOTICE
Follow the manufacturer’s instructions on the tube for proper
application. Allow at least 24 hours for caulk to set before
using the bathtub enclosure.
The installation is now complete. DO NOT discard these
installation instructions. PLEASE LEAVE THEM WITH THE
HOMEOWNER.
Care and Cleaning
Swan Corporation high gloss products are stain and abrasion
resistant; however, the finish requires reasonable care.
IMPORTANT NOTICE
Because cleaning products change over time, always check
the manufacturer’s instructions to make sure it is compatible
with fiberglass reinforced polyester. DO NOT use a cleaner if
the label indicates it should not be used on fiberglass
reinforced polyester. DO NOT use spray-on cleaners that
require daily use without immediately rinsing with water to stop
the chemical cleaning reaction because damage will result
and void the warranty.
Swan 18 800-325-7008
Installation Procedure Care and Cleaning