Installation Guide

Wall Kits With Separate Corner Panels -
TW-32, WW-6000, SW-7036, and SW-7060
SW-7036 SW-7060
TW-32
WW-6000
SW-07038AD
Corner Panels
Many corner panels are oriented to be installed a certain way.
Check for identification tags on the back of panels. Molded
in shelves must be installed with the flat surface facing up.
Corner panels without tags or molded in features may be
interchangeable.
1. Select either a left or right corner panel. Trial fit the corner
panel, and make any necessary adjustments.
Note: Corner shower wall kits only have one corner panel.
Install it with the flat surface of the molded shelf facing up.
IMPORTANT NOTICE
Model SW-7036 and SW-7060 Shower Wall Kits. The sides
of the corner panels are different widths. One side is 6 inches
wide and the other is 8 inches wide. The orientation of the
corner panel will affect the allowable width of the wall
dimensions. Refer to the illustration for proper orientation.
8”
8”
34”
or less
Over 34”
BACK WALL
SIDE WALL
BACK WALL
SIDE WALL
6”
6”
WARNING
Fumes Hazard
The fumes from the silicone sealant and
solvents used by the installer can be harmful if
used in an unventilated room. Always work in a well-
ventilated area. To keep the area well-ventilated, open
windows and use exhaust fans. If adequate ventilation is
not achievable or practical, use respiratory protective
equipment.
2. Clean the back of the panel with denatured alcohol.
IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from properly adhering to the wall.
3. Apply the silicone in 1-1/4 inch diameter dots every 8 to
10 inches over the back surface of the panel. Follow the
silicone manufacturer’s instructions and note all ventilation
and installation precautions.
Swan 8 800-325-7008
Installation Procedure