Installation Guide

Care and Cleaning
Swan products are stain and abrasion resistant;
however, the finish requires reasonable care.
Because cleaning products change over time, always
check the manufacturer’s instructions to make sure it is
compatible with plastic. DO NOT use a cleaner if the
label indicates it should not be used on plastics. DO NOT
use spray-on cleaners that require daily use without
immediately rinsing with water to stop the chemical
cleaning reaction because damage will result and void the
warranty.
Day-To-Day Cleanup
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swan products can be
cleaned with warm water, a soft cloth, and normal
household detergents or cleansers, such as Fantastic,
Formula 409, Clorox Clean-up, Handy Andy, Mr. Clean,
or Lestoil. Always rinse off cleaners within five minutes
of application.
If necessary, use an abrasive cleaner such as Ajax or
Comet with a nylon brush or pad to remove build up on
the pebble surface. Do Not use steel wool or a wire
brush. This will damage the surface.
Caulking Joints
Inspect all caulking joints monthly for damage or any
signs of separation from the mating wall surface.
Cracks in the caulking will allow water to leak into the
surrounding surfaces. Reapply caulking to any joint
showing signs of wear or cracking. Failure to inspect
and repair caulking joints will void the warranty.
Surface Repair
Light Scratches
Use 400 grit sandpaper to remove light scratches in the
surface.
Deep Scratches or Gouges
For deeper scratches or gouges, use 220 or 320 grit
sandpaper. A “Scotchbright pad” can be used to blend
the repair into the surrounding area.
IMPORTANT NOTICE
The Swan Corporation – Swanstone 14 800-325-7008
Maintenance & Surface Repair