Operation Manual

4
HOW TO USE
Parts
1. Water tank
2. Lid
3. Lid handle
4. Filter housing
5. Thermal mug lid
6. Thermal mug
7. Mug tray
8. On button «Start»
9. Filter holder
10. Filter
11. Measuring spoon
PREPARATION & FIRST USE
Unpack the unit completely and remove any stickers that can
prevent unit operation. Check the unit for damage, do not use it in
case of damage.
Before switching the unit on, make sure that your home mains
voltage corresponds to unit operating voltage.
Wash all removable parts: the thermal mug (6) with the lid (5), the
holder (9), the filter (10) with warm water and neutral detergent.
Rinse and dry thoroughly.
Install the holder (9) in such way that the holder handle is on the left
(pic. 1).
Install the filter (10) into the holder (9) in such way that the filter handle is on the right (pic. 1).
Fill the mug (6) with clean water.
Open the lid (2) and pour the water from the mug (6) into the water tank (1). The water level
should not exceed the «MAX» mark.
• Put the mug (6) on the tray (7). Use the mug without the lid (5).
• Insert the power plug into the mains socket.
• Press the «Start» button (8).
• When the mug (6) is filled with water, remove it from the tray (7) and discard the water.
• Let the unit cool down for 5 minutes.
• This process will clean all the internal components and ready your coffee maker for use.
MAKING COFFEE
The Coffee 2 Go drink is made by passing of hot water through a layer of ground coffee (or
loose tea) in the filter. The taste of the finished drink depends on the quality of raw products,
that’s why we recommend using good quality ground coffee beans and high-quality loose leaf
tea.
• Open the lid (2), install the holder (9) in such way that the holder handle is on the left
(pic.1).
• Install the filter (10) in such way that the filter holder is on the right (pic. 1).
• Measure the required amount of ground coffee or loose tea and put it into the filter (10).
1-2 scoops is typical amount depending on taste.
• Fill the mug (6) with water and then pour the water from the mug (6) into the water tank
(1). The water level should not exceed the «MAX» mark.
• Close the lid (2).
• Put the mug (6) on the tray (7). Use the mug without the lid (5).
• Insert the power plug into the mains socket. Switch the coffee maker on by pressing the
«Start» button (8), the button indicator will light up.
SK32010N_IM.indd 4 31/01/2014 10:35