Operation Manual

9
Press down steam button lock and then push it backwards, steam button will
automatically lock . Steam will be produced continually.
If you want to stop steam, please push steam button lock forward.
Notice: Always turn steam lock off when resting iron on its base or if you leave the
iron unattended
Auto-locking function for steam button
Pump overheat protection function
Handle attached to the base unit used for carrying the appliance. Press two handle
buttons at same time to lay down the handle (Fig.7). After use, allow the appliance
completely cool down, put the iron onto power base. Lift handle up (Fig.8). There will
be a “click” sound to indicate the handle has been locked in place and you
can carry the appliance by the handle.
The pump has an in-built overheat protection circuit. When water in water tank has been
used up the pump will be hot. If temperature of pump exceeds
its Max limit, overheat protection will automatically activate to protect pump being
damaged. At this point the, pump indicator light will turn off, please turn power
switch on base unit off and then check if water tank has sufficient water or
water tank has been properly installed. If not, please refill water tank and re-install
water tankinto base unit. Wait 30 minutes for the pump to cool and work again
Use of the handle
Fig.7 Fig.8