Installation Guide

IMPORTANT NOTICE
IMPORTANT NOTICE: Indicates that equipment or property
damage can result if instructions are not followed.
Read and Understand the Manual
It is the responsibility of any individual who installs or
maintains this product to fully understand and follow
proper installation and maintenance procedures. Be aware of
the inherent dangers in the use of power tools when installing
this product. Read and understand all Warnings, Cautions, and
Important Notices in this manual.
Work Safely
DO NOT proceed if any doubt arises about the correct
or safe method of performing anything found in this or
other Swanstone manuals. The installation of this product can
require using power tools. Do not use power tools without
adequate training. If necessary, hire or consult a trained
professional for expert assistance before continuing.
Use Proper Tools
Always use proper tools which are in good, working
condition during the installation of the Swanstone
products. Using tools other than those listed could adversely
affect the integrity of floors, pipes, walls, or this product and
could result in water damage or other damage to floors, pipes,
walls, or other portions of your building or home.
Do Not Use Nails
The panels mount to walls with 100% clear silicone
sealant only. Swan recommends 100% clear silicone
sealant to mount this product. It is NOT recommended to use
GE brand of 100% silicone. Never use hammers, nails, or
screws. Hammers, nails, and screws could adversely affect the
integrity of this product. Nails and screws could puncture the
Swanstone Wall Systems and Panels, resulting in water or
other damage to floors, pipes, walls, or other portions of your
building or home.
Inspect Before Cutting
Make sure no electrical wiring or plumbing is present
before cutting into a wall to install any accessories.
Wall Conditions
Inspect the walls before installing the Swanstone
panels. Never install panels over damp walls or an
existing mold condition.
CAUTION
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in injury. It may also be
used to alert against unsafe practices.
Use Proper Installation Methods
Follow all instructions related to wall surface
preparation. Failure to follow such instructions could
cause the panels to detach from the wall surface after
installation, resulting in personal injury. Failure to follow these
instructions could result in water damage.
The Swan Assurance — if our product is
properly installed and maintained, as stated in
these instructions, it will not leak.
Remember –
Safety First
IMPORTANT NOTICE
The Swan Corporation, the makers of the
Swan products, cannot anticipate every
possible circumstance that might involve
a potential hazard during the installation
of our product(s). The warnings and
instructions in this installation guide
are, therefore, not all-inclusive. If a tool,
installation procedure, or work method
that is not specifically recommended by
The Swan Corporation is used, you must
satisfy yourself that it is safe. You should
also make sure that the Swan product(s)
will not be damaged by the methods you
choose. The Swan Corporation will not be
held responsible for water damage of any
kind in connection with the installation of
one of our Swan bath/shower/panel kits.
WARNING
To avoid product damage, personal injury,
or even possible death, carefully read,
understand, and follow all the instructions
in this installation guide before installing
this product(s). Do not use cleaning
fluids or operate power tools unless you
read and understand the instructions
and warnings in this and all other
applicable labels or manuals. Proper use
of tools and the products described in
this guide is your responsibility.
WARRANTY
This product is covered by a Limited
Lifetime Warranty. Refer to the Warranty
section in this manual for complete details.
Save this manual for future
reference.
Important information on cleaning,
maintenance, and repair is contained
within.
Safety Guidelines