Instructions / Assembly

KSEU-3020 39 3/8” x 20”
(1000mm x 508mm)
DEPTH 8” (203mm)
DEPTH 7” (178mm)
Model A B C D
KSEU-3020 13” 16 1/2” 12 1/4” 7”
(330mm) (419mm) (311mm) (178mm)
KSTB-4422 14 3/8” 18 1/2” 16” 9”
(365mm) (470mm) (413mm) (229mm)
INSIDE BOWL DIMENSIONS
The Euro Style Bowl design allows for the drain
board to be located on either the left or right side
and comes with a white colander.
A
B
C
D
15 1/2” (394mm)
SINK CUTOUT MEASUREMENTS
Model Width Depth
KSEU-3020 38 3/4” (984mm) 19 3/8 (492mm)
KSTB-4422 42
1
⁄2” (1080mm) 21
3
⁄8” (543mm)
Measure the cutout line or the pre-cut opening to be sure it conforms to the sizes listed.
KSTB-4422 44” x 22”
(1118mm x 559mm)
DEPTH 9” (229mm)
DEPTH 9” (229mm)
DEPTH 7
1
⁄2” (191mm)
A
B
C
D
No template is provided for the installation of
these two kitchen sinks. To install, Invert sink
and position onto the countertop. Locate sink
front to rear and right to left so the bowl will
not interfere with the cabinets below. Trace a
pencil line around the outside edge of the sink
and remove the sink from the countertop.
Measure in 5/16" (8mm) from the initial sink
outline and draw a second line inside the first.
Draw a 1-1/2" radius at each corner. The sec-
ond interior line will be your cut out line.
Follow steps 2 through 6 to complete drop-in
kitchen sink installation. If you require an
undermount template for either of these two
sinks, please call Swan customer service at
1-800-32-7008.
Drop-In Kitchen Sink Installation Instructions
For The Following Models ––No Template Provided
The Swan Corporation One City Centre Suite 2300 St. Louis, MO 63101 800-325-7008
Form 254-9-02-20M