Installation Guide

IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from properly adhering to the wall.
3. Apply the silicone in 1-1/4 inch diameter dots every 8 to
10 inches over the back surface of the panel. Follow the
silicone manufacturer’s instructions and note all ventilation
and installation precautions.
4. Install the back panel. Carefully center the overlapping
panel and press firmly to the wall. Keep the top edge of
the panels aligned when installing adjacent panels. Use
even hand pressure from top to bottom and side-to-side to
ensure solid wall contact.
Note: Any gaps between the bottom of the panels and the tub
ledge will be filled in with caulking in a later step.
Extension Panel (Model SW-7060)
IMPORTANT NOTICE
This kit has an extension panel to fit back wall measurements
from 36 to 60 inches wide. The extension panel is the same
size as the side panels, but it has two overlapping edges and
is clearly marked on the back.
Note: For the SW-7060 Wall Kit, measure the distance
between the back wall edges of the two installed corner
panels. If the back wall measurement is 29 to 47 inches, refer
to Step 1. If the back wall measurement is
47 to 51 inches, refer to Step 3.
1. Measure the distance between the back wall edges of the
two installed corner panels. Subtract
23 inches from this measurement to determine the
minimum required width of the extension panel.
Example :
36 in = width between back wall corner panels
-23 in = minimum coverage width (with 1 inch overlaps)
13 in = width of cut extension panel (minimum)
Note: If the back wall measurement is 29 inches or less, cut
the extension panel to a 6 inch width. DO NOT CUT THE
EXTENSION PANEL TO A WIDTH LESS THAN 6 inches
wide.
Swan 12 800-325-7008
Installation Procedure