Installation Instructions

u System Setup iOS
1. After registration, you can add
devices by tapping “Settings” in
the upper left corner, then
tapping “+ Add Devices”.
2. Choose add “Camera” by
tapping the camera icon in the
center of the page.
The camera LED will be flashing and you
will hear the voice prompt of “SwamCam is
ready for setup …”. If not, the camera may
not be properly reset. You can insert a
paperclip into the pinhole on the camera’s
left side and have it reset. Push and hold
the paperclip until you hear the voice
prompts.
3. Respond to the question on-
screen. If the LEDs are flashing
green to red, select Yes. If they
are not, select No. You will be
provided with reset instructions if
the LEDs are not flashing.
4. After naming your device, you will
be prompted to enter your existing
Wi-Fi password:
!
!
u Mobile App Password Reset
1. If you forget the password, you can
tap “Forgot your password” on the
login screen.
2. Then enter the email address you
used to register this account.
3. A verification code will be sent to that
email address.
4. Create a new password according to
the requirements.
!
29!
4!