Installation Instructions

u Using the Keypad
The Default Code for the keypad
is 1234. The Keypad requires
2xAAA batteries to function.
In order to use the Keypad, you
must “wake it up” by tapping any
key on the screen. Once it wakes
up, the Keypad will light up and
you can enter the Code and
choose ARM or DISARM.
You may change the Code for the
Keypad by doing the following:
1. From Settings, tap Device Information
(note: battery status is available on
this section)
2. Expand the Keypad section and Tap
Keypad
3. Enter the current Code. If setting up
for the first time, the current Code is
1234
4. Tap OK when complete and test the
new Code.
If you forgot your Code, see Resetting the
Access Code.
!
u Using the Alarm
1. To mute when alarm is sounding either tap mute on
Live View or press the button on the Repeater
2. The Alarm/Repeater has 2 alert modes; siren and
voice prompt. You may toggle between the 2 alerts by
pressing the button on the Alarm/Repeater until you
hear Motion Detected.
3. To return to using the siren, press and hold the button
on the Alarm/Repeater until you hear Motion Detected
Finished.
u Using the Alarm as a Wi-Fi Repeater
!
The Alarm can be used as a Wi-Fi Repeater for other
devices as well (ie. Phone, laptop…). Our devices
automatically join the repeater or your home router,
depending on which has the best signal.
The Repeater acts as an extension of your home router
and extends your network seamlessly. As long as your
devices are connected to your home Wi-Fi network, the
signal will carry-over to the SwamCam repeater as
needed.
Proper placement of the Alarm/Repeater will ensure a
good signal for the SwamCam system. Typically, a home
router will provide most of the home with Wi-Fi but is not
strong enough to carry the signal out to the pool area.
!
17!
16!