User Manual

16
ENGLISH SWAGTRON EB10 Electric Bike
Section 6. Maintenance
• Do not perform any kind of maintenance while the eBike is charging.
• Attempting to repair or modify your eBike can void all warranties. Only authorized repair centers may service the eBike.
If you need assistance, please contact customer service.
6.1 Tire Ination
You will need a pressure gauge and a standard bicycle pump to inate the EB10 eBike’s tires.
Step 1. Ensure the eBike is powered off and stable, so it doesn’t move during ination.
Step 2. Visually inspect the tires for damage, scuff, or puncture marks. If the tire is damaged, DO NOT INFLATE IT. Contact
customer service immediately.
Step 3. Find the valve located on the inside of the wheel and remove the cap.
Step 4. Use a standard bicycle pump to pump air to the tires slowly.
Step 5. Use the pressure gauge periodically to check PSI.
Step 6. When the tire reaches 45 PSI, stop inating and replace the valve cap.
Step 7. Repeat with other tire.
•AnyPSImarkingonthetiresindicatesamaximum.DONOTinatethefronttiretothisvalue,onlyinateitto45PSIas
directed above.
•Underinationisstronglyrecommendedifyouintendtorideoutdoorsintemperaturesabove90°F.Insuchconditions,
bring the EB10 indoors and deate the tires by 3-5 PSI. If the PSI is too high and the tire are exposed to excessively
high temperatures, riding outdoors may cause serious damage to the tire including but not limited to stretching and/or
rupturing.