User Manual

7
ENGLISHSWAGTRON EB10 Electric Bike
2.2 Assembling and Adjusting the Handlebars
A top cap has been installed on the handlebar stem bolt by default. Remove it
before installing the handlebars.
Assembling the Head
Step 1. Remove the stem bolt cap.
Step 2. Use the included allen key to loosen the stem bolt.
Step 3. Insert the stem into the fork locknut to the desired height. Make sure the end
mark is completely inserted so that the end is below the lock nut.
Step 4. Align the stem with the front tire and securely tighten the stem bolt.
Step 5. After assembling the head, make sure the handlebar stem is in line with the
top tube (Fig. 3).
Adjusting the Handlebars
Step 1. Use the included wrench to slightly release the screw of the top cap from
the handlebar stem.
Step 2. Adjust the direction of the handlebars to a comfortable position.
Step 3. Use the wrench to tighten the screw and x the handlebar stem in place.
Step 4. Check it again to make sure the handlebar stem is in line with the top
tube, then use the wrench to tighten the screw and x the handlebar
stem in place (Fig. 4).
Screw
Fig. 4
Fig. 3
Stem Bolt
Cap