User's Manual

 PUK: Your SIM or USIM card is blocked, usually as a result of entering your PIN
incorrectly several times. You must enter the PUK supplied by your service
provider.
 PIN2: When you access a menu requiring the PIN2, you must enter the PIN2
supplied with the SIM or USIM card. For more information, contact your service
provider.
The battery icon is empty
Your battery is low. Charge the battery.
The battery does not charge properly (For Service-approved chargers)
 Ensure that the charger is connected properly.
 Visit a Service Centre and have the battery replaced.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
SAR tests are conducted using standard operating positions accepted by the FCC with the