User Manual

INSTALLATION SVS CYLINDER SUBWOOFERS

SVS Cylinder Subwoofers:

1. Using a helper as needed, lay the cylinder subwoofer sideways on a stable surface.

Take care to avoid damaging the ampliﬁer.

2. Peel off the original equipment (OE) rubber disc feet.

3. Only remove one (1) OE machine screw at a time.

This will prevent the base plate from dislodging.

Important Notice: - If you are using a powered bit driver

to remove and/or install the machine screws, avoid

excessive downward pressure on the screw, as that may

dislodge the t-nut mounted to the backside of the

woofer end-cap.

4. Install the Isolation foot by inserting the OE

machine screw through the bottom opening of the

rubber foot, through the opening in the steel outer shell,

through the base plate, through the dowel (re-aligning

the dowel as necessary) and into the t-nut on the

backside of the woofer end-cap.

5. Make sure the machine screw is correctly aligned

and does not cross-thread.

6. Tighten the OE machine screw avoiding excessive

downward pressure. Once the screw fully tightens and

starts to pull against the end-cap t-nut, tighten securely

using hand-pressure.

7. Using a helper (if needed), carefully stand the

cylinder subwoofer back onto the installed Isolation

feet. Take care to avoid damaging the ampliﬁer.

Important Notice: - Do not drag the subwoofer base plate across the

ﬂooring with the Isolation feet installed. This may damage the Isolation

feet or the base plate. If you need to move the subwoofer, always lift (use

a helper if needed) the subwoofer and then place it into the new location.