Owner's Manual

the free DTS Play-Fi app to start unlocking the full potential of your new Prime Wireless Speakers.
2. WiFi Set-up Mode
Once powered on for the first time, the active Prime Wireless Speaker will automatically go into Wi-Fi setup
mode, indicated by a rapidly blinking yellow light on the rear panel of the speaker. When the blinking light slows
down to a slow pulse, the speaker is ready to connect. Wi-Fi connection will be confirmed when yellow light
remains on permanently.
3. Connect Speaker to WiFi Network
iOS users must go to the “Settings” -> “WiFi” on their mobile device and select the “PlayFiDevice…” like you
would a normal Wi-Fi network then open the Play-FI app to continue.
Android users proceed directly to step 4.
4. Configure Play-Fi App
Open the Play-Fi app and follow the prompts to finish setting up your Prime Wireless Speaker System on your
home Wi-Fi network (image 9a and 9b) .
From here, the app will find your new Prime Wireless Speakers and connect them to the Wi-Fi network for you.
NOTE: You will type in your network password once (image 9c), and the app will do the rest. It’s important not
to close or exit out of the app until the process is fully complete or it may disrupt the configuration.
During installation, the Play-Fi app will look for and install any updates. These product updates add 3-5 minutes
to the installation time.
Once network set up and updates are completed, you can select a name for your new Prime Wireless Speaker
System (image 9d) , control volume (image 9e) and start enjoying music from your favorite streaming services
(image 9f) .
Image 9a. Image 9b. Image 9c.
Image 9d. Image 9e. Image 9f.