Instruction manual

VISS3000

SVAT ELECTRONICS

Now You Can See

OPERA

TION INSTRUCTIONS

How to operate when the intercom rings:

1.Chime ‘ding dong’ can be heard when visitor presses Call button on the

outdoor station.

2.Press ‘Monitor’ button to communicate with visitor

3.If your door is equipped with a door strike, pressing the ‘Unlock’ button will

release the door.

How to operate the monitor without any visitors:

1.Press the ‘monitor’ button, a picture from the camera appears.

2.Press the ‘monitor’ button again to switch off monitor, or monitor will auto switch

off after 30 seconds.

How to adjust and display time and date:

1.With the monitor turned on, time and date will be displayed at the bottom of

screen as Year/Month/Date/Hour/Minute.

2.Press the 'Time' button, a minute number will twinkle, then press 'Play' button to

adjust minutes; press Time' again, Hour number will twinkle, press 'Play' to adjust

hour; and so on and so forth, to adjust year, month .etc.

3.Press 'Time' button once more to finish and save the setting.

Automatic image capture:

1.Press the ‘mode’ button to turn auto-recording on. (LED should illuminate)

Press again to turn this feature off.

2.After a visitor presses the ‘call’ button, the monitor will take a snap shot from

the camera and save it into memory. At the top of the screen, words 'PXX'

displayed, 'XX' means the number of picture.

(Example: the number of first picture is P01)

3.The current time and date will also be embedded into the picture.

4.The max capacity of storage memory is 32 pictures. P01 picture will be auto

replaced by P33 picture.

Viewing saved imaged:

1.Press the 'Monitor' button, the screen start to work, pressing the 'Play' button will

display the last saved picture. Press 'Play' button one more time, to view the next picture.

2.Holding the ‘Play’ button for more then 3 seconds will turn the monitor into a

“browse’ mode which will scan through all images in 0.5 second intervals.

3.CAUTION: Unplugging the monitor from the wall outlet (main power source) will

cause the saved images to be deleted.

Manual recording function:

1.When the monitor is turned on, press the 'Record' button to capture the current

image from camera.