Instruction manual

VISS6002
7
SVAT ELECTRONICS
Now You Can See
MONITOR INSTALLATION & OPERATION
USING THE MONITOR
• When the monitor is in standby, pressing the Talk/View button turns the monitor and
outside camera ON. Monitor and camera will automatically turn off after 1 minute.
*NOTE* The camera’s CALL button must be pressed first by the visitor, followed by
the Talk/View button in order to speak with your visitor.
DETERRING UNWANTED VISITORS
• If you discover unwanted visitors, pressing the WARNING button on the monitor will
engage a loud siren in the outside camera in order to deter the visitor.
ADJUSTING PICTURE/VOLUME
• Volume and Brightness knobs are located at the side of the monitor for fine tuning.
DOORSTRIKE
• This system supports any door strike rated between 12-14V DC. The door will remain
unlocked for 10 seconds. Please refer to the wiring diagram for installation.
(Doorstrike not included)
145cm ~ 160cm
AC: 110 ~ 240V
The optimum height of the
monitor for installation is
145cm ~160cm from the
center of the pick-up tube of
the monitor to the ground.
Take two screws and fix the support of
the wall-mount on the wall and then
install the monitor.