- SVAT 2.4 GHz Wireless B/W Security System User's Manual

If you are not getting any signal at all

• Check the power on the camera and monitor

• Make sure power plugs are pushed all the way in

• Check the CHANNEL switches on both camera and monitor are set to the same number

• If the camera/monitor is powered by batteries, replace all batteries with new ones

• If you can receive sound, but don't have images, or the images are poor, check the SCREEN ON/

OFF button on the front panel, or adjust the V-HOLD/ CONTRAST/BRIGHTNESS knob on the

rear of the monitor

If the signal is poor, or there is interference

• Adjust antenna orientation

• Change the channel settings on both camera and monitor and make them the same

• If there is a microwave oven in use in the path between the camera and monitor, remove the

microwave oven or turn it off

• Make sure the camera and monitor are within range (up to 300 feet)

• Check the channel dipswitch positions on the monitor.

Troubleshooting

PDF created with FinePrint pdfFactory trial version www.pdffactory.com