User's Manual

Quantum - Tool Recognition
Introduction
Doc-0001374, Rev B
Sida 5
RSS standard
This equipment is exempt from the routine RF exposure evaluation requirement of RSS-102.
This equipment should be installed and operated with a minimum distance of 20 cm between
the antenna and the user or bystanders. This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Ce matériel n’est pas sujet à l’évaluation habituelle d’exposition RF selon RSS102. Ce matériel
devrait être installé et exploité en gardant une distance minimale de 20 cm entre l’antenne et
l’utilisateur ou lesspectateurs.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
CAN ICES-3 (B)/NMB-3(B)
Contact SVAB at:
SVAB, Ulvsättersgatan 2SE-694 35 Hallsberg
Phone: [phone] (main) [phone] (Support)
On our website www.svab.se you will nd additional information.
Support
Approved areas of use
If you are unsure whether the function is allowed to control, always ask a technician from
your system provider.
Approved areas of use for Quantum ToolRec:
- Tool recognition on excavator
- Provide input signal to compatible systems
Quantum shall only be used for approved areas of use and functions as mentioned above.
SVAB will not take part in injuries or accidents that occurs due to unauthorized use.
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.