User's Manual

Quantum - Tool Recognition
Introduction
Doc-0001374, Rev B
Sida 4
Introduction
Quantum Tool Recognition is a system for wireless toolrecognition on excavators. This is
the only usage intended for this product. All other usages of this machine, without written
permission from SVAB, are strictly prohibited.
This document gives instructions how to do installation work on a Quantum Tool
Recognition system. SVAB reserves the right to change the contents of this instruction at
any time without further notice.
SVAB develops and produces their products in accordance to european legislation and teh
macinery directive 2006/42/EG. The CE marking shows that the system fullls the directive
of electromagnetic compatibility EMC, RoHS and radiodirective RED.
This installation instruction shall be used in the technical le which will be the base for
the nal CE marking of the machine. Therefore, the checklist in this instruction shall be
thouroughly performed, completely lled out and signed by responsible tter. Save this
instruction in the technical le.
The installation of the system referred to in this document is to be performed by
experienced personnel. If there’s unclarities regarding the use, installation, understanding
of the system or regarding this document - disengage the installation work and contact
the system provider for information. By using common sense you can avoid accidents from
happening yourself.
This instruction is protected by copyright and may not be reproduced, distributed or
altered. Violation of the law may lead to prosecutions and nes, imprisonment or duty to
pay compensation to the creator / proprietor.
FCC and ISED
Changes or modications to the equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure,
the antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from any persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
General