User's Manual

Quantum - Tool Recognition
Maintenance
Doc-0001374, Rev B
Sida 23
Replace TRM
The TRM-module should be mounted on the tool in room temperature for best
result. The temperature may not go under - 10 grader C.
The module is delivered with the battery, sealing and screws on the side.
1. Remove the old TRM from the tool
2. Clean the surface before mounting the new module.
3. Remove the cover on the module and install the battery.
Install the seal.
Make sure that the seal ts the groove properly.
4. Put the cover back.
Make sure to turn the cover in correct position so the notch [2] ts
the battery.
5. Note the MAC-adress on the module. This number will show up in the app
later on. You will nd the label on the side of the module. Example of a MAC-
adress: C6:6D:D5:27:4F:B5.
6. Install with optional cover:
Weld or screw the cover to the clean surface.
Remove the tape underneath the module and press the module to the
bottom of the cover.
7. Install without optional cover:
Remove the tape underneath the module and press the module to the clean
surface
P-0001304
Seal