Specifications

Start up

Start up the system

Quantum starts when the machines electronics is activated by the ignition.

Start the Quantum hub

1. Power up the machine.

Quantum hub will start and the diodes will start to flash. The LEDs are called (from

the left):

LED 1, LED 2, LED 3, LED 4.

LED 1 (Heartbeat), LED 2(TOOLREC-searching), LED 3 (quickcoupler), LED 4

(TOOLREC-status)

2. Check that LED 1 is flashing

green. As long as the hub is run-

ning, the led will flash.

3. LED 2 flashes blue when

searching for a tool. If LED 2 flash-

es green, it searches for a tiltrota-

tor. If LED 2 flashes blue and green

respectively, it searches for both til-

trotator and tools.

4. Check lower coupler function by

activating it. LED 3 lights up with a

green steady light.

5. Check upper coupler function by

activating it. LED 3 lights up with a

red steady light.

If both couplers are open, LED 3 lights up

with a yellow light.

6. When a tiltrotator has been iden-

tified, LED 4 lights up with a green

steady light. When a tool has been

identified, LED 4 lights up with a

blue steady light.

Quantum