Specifications

3. Remount the cover and tighten the screws at 0.8 Nm.

4. Find a protected surface for the module. On top of the tool, close to the attachement is one good

placement, se examples below.

5. Clean the surface where the module is placed.

NOTE

The surface needs to be clear from dirt and should be dry. Use some kind of lipo-

soluble spray for the task. Avoid circling movements, keep one direction if possible.

6. For optimal function, make sure that the module is rotated correctly before mounting. Follow the di-

rections on the module cover:

7. Installation with protection cover: Weld or screw the protection cover to the clean surface. Remove

the tape underneath the module and press the module to the bottom of the cover.

CAUTION

Make sure that the hub is powerless by disconnecting the power cable before any

welding is started.

Quantum