User's Manual

KI-3101 user manual
Company：Suzhou Switek Electronics&Technology co.,ltd
Website：http://www.lanbe.com/
E-mail:[e-mail]
LANBE is looking forward to cooperate with you again
25
f) What's the maximum of logs and how to record for exceed?
1000,it will cover the previous previous once exceed.
g) How to wake up it after product sleep?
The product is the design of low power consumption,and it will into state of
dormancy after check the kayboard and mouse after 10-20s without any
action.PC conrtol port will appear standby and it's also ok to use.Using mouse
click the control area slightly to wait 5-10S to wake up it,it needs to press "CTRL+
↓"after selecting no local mouse mode if you want to exit remote control
interfac.It not allowed to move windows key when PC is controlling interface
operation,otherwise will lead to the mouse will jump automatically.
h) When will need to adjust frame rate and bit rate?
Under the better network,it more smoothly and the clearer image;If bad network
or limites,you can improve the fluency of image by reducing frame rate and bit
rate,but lower frame rate and bit rate will lead to the bad image.
i) How to take effect after changed new IP address?
It will only take effect after needs to restart the device if you changed the network
of KI-3101(IP address and subnet mask).It not allowed to move the PC software
during restart devide,it only to wait it to automatic off.
j) What's the difference between user permissions?
Administrators have the highest permissions,administrator will get the operation
permissions after login,but intermediate user only can get it after administrator
exited it.
FCC Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna