User's Manual

3. CPU Port Section
 The cables that link the switch to your computers plug in here. Each CPU port is comprised of a KVM data
connector.
NOTE: The shape of these 15-pin connectors has been specifically modified so that only KVM cables designed
to work with this switch can plug in. Do NOT attempt to use ordinary 15-pin VGA connector cables to link
these ports to the computes.
INSTALLATION
BEFORE YOU BEGIN
1. Make sure that power to all the devices you will be connecting up have been turned off.
2. To prevent damage to your installation, make sure that all devices on the installation are properly grounded.
SINGLE STAGE INSTALLATION
To set up your AS-9104DU/AS-9108DU/AS-9116DU installation, do the following:
1. Plug your USB / PS/2 keyboard, USB / PS/2 mouse and monitor into the console port section located on the
unit’s rear panel.
2. Using a KVM cable set, plug the custom SPDB connector into any available CPU port on the switch.
3. At the other end of the cable, plug the keyboard, mouse, video cables into their respective ports on the
computer.
4. Plug the power adapter cable into the switch’s power jack, then plug the power adapter into an AC power
source.
5. Repeat step 2-4 for any other computers you are connecting up.
This completes the single stage installation, and you can turn on the power to the computers.
NOTE: The AS-9104DU/AS-9108DU/AS-9116DU initially links to computer connected to the first CPU port.