User's Manual

LCD KVM Console User Manual
57
 DVI single port LCD KVM Switch
Note
：
Connect the DP37 port to the corresponding port on the back of the LCD, and then connect the video
port of the other end to the video port of the computer. Then connect the port of PS2 or USB to the
corresponding keyboard and mouse port of the computer, then power the computer and the LCD KVM
switch.
Cascade Device Connection
This product can be cascaded to increase the number of control devices, combined with IP remote control
mode can be flexibly used in a variety of user environment requirements.
 VGA Port LCD KVM Switch Cascade
In the VGA switch Cascade mode, the keyboard, mouse and computer connections is same with the
stand-alone connection, this part will not repeat them, the number part of the description is as follows:
1. A cascaded KVM switch can be connected in two ways by using a USB KVM cable (as shown
in connection number 2 in the figure) or a PS2 KVM cable (as shown in connection number
1 in the figure) Connect to the upper-level switcher.
2.The number of computers connected to each level can be freely increased or decreased according to your
requirements. Refer to the connection method shown in figure 3.
3. Between the level of IP module can be optional remote control, can also be handed over to the KVM
switch from the top of the local and remote as a unified control and management operations.
Note
：
This product cascade mode is divided into two levels, so you need to set the cascade connection mode
switch OSD Menu with two levels of hotkey for two different hotkey combinations, or the OSD can not be
started when cascade.(Refer to the OSD chapter for details on the OSD Hot Key settings.)
Connection diagram please see the following figure (VGA port LCD KVM switch cascade)