User's Manual

z Press LCD power key (red), the LCD is on.

After Use

z Press LCD power key, the LCD is power off.

z Close LCD panel and lock the front panel.

z Release guide lock.

z Push the control panel into the cabinet totally, and then it is power off.

Hot Plug

The CAT5 LCD CONTROL PLATFORM supports hot plug. It can be connected and disconnected

without power off. Please follow the steps:

 Hot plug PC connecting port:

When hot plugging PC port:

1. The connecting wire must be plugged into the port from which it is pulled out.

2. Plug the mouse before the keyboard.

Note: The CAT5 LCD CONTROL PLATFORM must be power on before PC.

Power On/Off and Reboot

If user needs to cut off the power of CAT5 LCD CONTROL PLATFORM, please follow the steps

before power on again.

1. Cut off the power supply of all computers.

Note:

1) The power wire of computer with keyboard power on function must be pulled out. Otherwise, the

CAT5 KVM still receives the power signal from computer.

2) If the control unit uses the external power, please pull out external power.

2. After about 10 seconds, power on the CAT5 LCD CONTROL PLATFORM.

3. After the CAT5 LCD CONTROL PLATFORM starts, power on the computers.