Product Info

15
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular.
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in a
host, host manufacturer have to consult with module manufacturer for the installation method in
end system.
2.4 Limited module procedures
Not Applicable
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
The device has been evaluated to meet general RF exposure requirement. in portable exposure
condition without restriction.
2.7 Antennas
This radio transmitter FCC ID: 2AXD8TURING has been approved by Federal Communications
Commission to operate with the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
Internal
Identification
Antenna
Description
Antenna type
and antenna
number
Operate frequency
band
Maximum
antenna gain
Antenna 1
Bluetooth
Antenna
Chip Antenna
2400 MHz – 2500
MHz
0.92 dBi
Antenna 2
Bluetooth
Antenna
FPC Antenna
2400 MHz – 2500
MHz
1.65 dBi
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:
2AXD8TURING”
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC requirements for the
transmitter when the module is installed in the host..
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all
other applicable requirements for the system such as Part 15 B