Installation Instructions
Table Of Contents
7
How to check the remaining power
Lightly press the indicator button on the power display panel, the corresponding power indicator lights up,
and automatically turns off after 2 seconds.
The remaining power value can be read by the LED light on and off.
1. Four green LED lights are on, indicating that the base station is at 100% power at this time
2. The three green LED lights are on, indicating that the remaining power of the base station is 75% at this
time
3. Two green LED lights are on, indicating that the base station is at 50% power at this time
4. A green LED light is on, indicating that the base station is at 25% power at this time
5. A red LED light is on, indicating that the base station is at 10% power at this time
Chcek List Before Use
1. Visual inspection
(1) Whether the RTK antenna is damaged
(2) Check whether the casing is damaged, so as to prevent the circuit board from being damaged due to
the entry of external water
(3) Whether the sealing plug is tightly closed to prevent the circuit board from being damaged due to the
entry of external water
2. Power-on check
(1) When the device is in the off state, after pressing the Power button (t>1.8s), the device will enter the
power-on state, and 10 LEDs on the interface will light up at the same time (mainly to check whether all
the LEDs work normally), and after 2s, enter the system initialization;
(2) System initialization:
1 PWR LED is always on;
2 The Battery LED first displays the battery level (3s) and then turns off
3 Function module LEDs (communication, WiFi/Bluetooth, DGPS, fault) turn on and off in sequence
4 After the startup is completed, the PWR LED continues to keep on
(3) Note
1 It can be turned off at any time during startup.
3. Shutdown check
(1) When the device is on or working: Press the Power button (2.5s<t<15s), the 9 LEDs on the interface will
turn off at the same time, and the device will enter the standby state first. If there is no instruction for
more than 10s, the device will enter the shutdown state ;
4. Battery check
(1) Short press the switch button (0.1s<t<0.5s), observe the battery light to display the remaining power;
(2) After pressing the Power button (0.1s<t<0.5s), the Battery LED will display the battery level (3s), and
after the display is over (>3s), the LED will turn off; if you press the Power button (t<0.1s or t>0.5 s), the
power is not displayed (the command is regarded as invalid);
5. Battery display
(1) In the case of non-charging,:after pressing the Power button (0.1s<t<0.5s), the user can check the
power according to the displayed power grid information. For example: when 50%<SoC<75%,