en SUUNTO COMBOS AND MECHANICAL INSTRUMENTS ASSEMBLY INSTRUCTIONS Combo Consoles I Console Compasses SK-8 Depth Gauge SM-16 I Pressure Gauge SM-36
SUUNTO COMBO CONSOLES The Suunto combo consoles for recreational use allow you to create a personal console according to your own specific needs. Analog gauges, dive computers and compasses fit together like building blocks. Suunto console compasses The Suunto SK-8 is available in two models, each with northern and sothern hemisphere balancing options. The SK-8 Console Mount, front attaches to the top of the combo module or the Cobra dive computer.
SK-8 CB-TWO + = CB-ONE + CB-DOUBLE SK-8 CB-TWO-IN-LINE SK-8 + CB-IN-LINE CB-DOUBLE-IN-LINE = + CB-ONE CB-THREE-IN-LINE + SK-8 2
1 2 3 (3) 5 4 (5) 1. CB-ONE module front cover with SM-36 pressure gauge in place (see section CB-ONE Module assembly) 2. CB-IN-LINE module front cover 3. CB-end piece or SK-8 Console Mount, front compass (optional) 4. CB-IN-LINE module back cover with instrument 5.
CB-ONE MODULE ASSEMBLY The CB-ONE Module is designed to fit the Suunto SM-36 analog pressure gauges. Before assembling the CB-ONE module the hose cover needs to be fitted on the pressure hose. The hose cover ensures that the SM-36 pressure gauge fits properly on the CB-ONE module. If the Suunto Quick Release is used, see section ‘CB-ONE module assembly with Quick Release.’ After attaching the hose cover the pressure hose and gauge are assembled on the CB-ONE front cover according to the picture.
CB-ONE MODULE ASSEMBLY WITH QUICK RELEASE If the Suunto Quick Release is used, the hose cover should be attached on the high pressure hose below the female end of the Quick Release. The male end is attached to the pressure gauge which is then fitted onto the CB-ONE front cover as shown below. CB-IN-LINE MODULE ASSEMBLY The CB-IN-LINE module fits the Suunto Vyper, Vyper Air, HelO2 and Zoop dive computers or the SM-16 depth gauge. The Vyper locks into place on the IN-LINE module back cover.
SUUNTO ZOOP NOVO AND VYPER NOVO COMBO MOUNT ASSEMBLY The combo mount for Suunto Zoop Novo and Vyper Novo locks into place on the IN-LINE module back cover.
BEFORE USE Depth gauge Before diving, check the position of the depth indicating pointer. Atmospheric conditions (altitude, temperature) may cause misalignment. Turn the adjustment screw located on the right side of the depth gauge to align the pointer to zero. The adjustment is to be made at the temperature of usage. Repeated unnecessary adjustments may cause excessive wear to the seals and eventual leakage. CAUTION! Do not attempt to adjust the water entry port located at the left side of gauge.
CAUTION: After use, rinse the gauges or the console with fresh water and store them out of direct sunlight, in a dry place at room temperature. CAUTION: Do not attempt to clean the gauges with anything other than water. Use of cleaning agents or compressed air can cause permanent damage. Inserting objects into the water entry port of the depth gauge or the pressure relief valve opening of the pressure gauge can damage internal components.
TECHNICAL SPECIFICATIONS The Suunto SM-16 complies with EN 13319. The tolerances are: At 3m +0.8 / -0.4 m At 6m +0.8 / -0.4 m At 9m ±0.8 m At 15m +1/ -1.2 m At 30m +1/ -1.2 m At 45m +1/ -1.5 m At 60m +1 / -1.5 m The Suunto SM-36 complies with EN 250.
SUUNTO CUSTOMER SUPPORT 1. www.suunto.com/support www.suunto.com/mysuunto 2.
