User manual
Table Of Contents
- 1 SAFETY
- 2 GETTING STARTED
- 3 FEATURES
- 3.1 Activation and pre-checks
- 3.2 Alarms, warnings and notifications
- 3.3 Apnea timer
- 3.4 Backlight
- 3.5 Battery indicators
- 3.6 Calendar clock
- 3.7 Display contrast
- 3.8 Depth alarm
- 3.9 Dive history
- 3.10 Dive modes
- 3.11 Dive time alarm
- 3.12 Sample rate
- 3.13 Stopwatch
- 3.14 Surface and no-fly time
- 3.15 Tones
- 3.16 Water contact
- 4 CARE AND SUPPORT
- 5 REFERENCE
If single free dive lasts longer than 10 minutes or if a dive is done in
Gauge mode (bottom timer), the no-fly time is always 48 hours.
WARNING: YOU ARE ADVISED TO AVOID FLYING ANY TIME THE
COMPUTER COUNTS DOWN THE NO-FLY TIME. ALWAYS ACTIVATE
THE COMPUTER TO CHECK THE REMAINING NO-FLY TIME PRIOR TO
FLYING! Flying or traveling to a higher altitude within the no-fly
time can greatly increase the risk of DCS. Review the
recommendations given by Divers Alert Network (DAN). There can
never be a flying-after-diving rule that is guaranteed to completely
prevent decompression sickness!
The Divers Alert Network (DAN) recommends the following on no-
fly times:
•
A minimum surface interval of 12 hours would be required in
order to be reasonably assured a diver will remain symptom free
upon ascent to altitude in a commercial jetliner (altitude up to
2,400 m (8,000 ft)).
•
Divers who plan to make daily, multiple dives for several days, or
make dives that require decompression stops, should take special
29