Operation Manual
Table Of Contents
- 1 Safety instructions
- 2 Registered trademarks
- 3 RF exposure information and statement
- 4 Application
- 5 Features
- 6 Technical data
- 7 Dimensional drawing
- 8 Determining the installation point
- 9 Installing the sensor
- 10 Sensor signal outputs
- 11 Service App S4C-FS
- 12 Calibration
- 13 Maintenance
- 14 Disposal or waste
- 15 Appendix A - Modbus communication example
- 空白页面
10 Sensor signal outputs
10 Sensor signal outputs
10.1 Analog output
The sensor has an analog output range of 4 ... 20 mA. This output can
be scaled to match a desired measuring range. Standard scaling is from
0 to max flow. The corresponding flow in different pipe sizes can be
found in the Appendix section. For other ranges, please contact the
manufacturer.
10.2 Pulse output
The sensor will send out one pulse per consumption unit. This pulse
output can be connected to an external pulse counter to count the total
consumption. The number of m
3
per second are summed up and
indicated after one second. Pulse length depends on flow rate.
S402 23