Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical Data
- 5. Dimensional drawing
- 6. Installation
- 7. Configuration
- 8. Sensor signal outputs
- 9. Calibration
- 10. Maintenance
- 11. Disposal or waste
- 12. Warranty
- Appendix
8. Sensor signal outputs
In case the flow rate is higher than 50 m
3
/s, l/s of ft
3
/s, the S430 can
not output the pulses with default settings (one pulse per consumption
unit). For this the pulse can be set by our service software or a
connected display to 1 pulse per 10 consumption units or 1 pulse per
100 consumption units. For example, if set to 1 pulse per 10 m
3
, the
sensor will send one pulse each 10 m
3
.
Example:
Volume flow
[m
3
/h]
Pulse length
[ms]
Max. consumption
[m
3
]
≦ 10800 120 10800
> 10800 60 28800
> 28800 30 57600
S430 29