Operation Manual
Table Of Contents
- 1 Safety instructions
- 2 RF Exposure Information and Statement
- 3 Application
- 4 Features
- 5 Technical Data
- 6 Dimensional drawing
- 7 Installation
- 8 Sensor signal outputs
- 9 Configuration
- 10 Data logging
- 11 Calibration
- 12 Disposal or waste
- 13 12 Warranty
- 14 Appendix A Specifications
- 15 Appendix B Modbus communication example
- 16 Appendix C LRC and CRC calculation
Installation
7 Installation
S 418 is delivered with following components:
Qty. Description Order no.
1 S 418 Thermal mass flow meter
S695 4180
S695 4181
S695 4182
S695 4183
S695 4185
S695 4186
S695 4187
S695 4188
1 5 m cable with M8 connector and open ends A553 0136
1 USB cable A553 0130
1 Instruction and operation manual No P/N
1 Calibration certificate No P/N
1
Serial number for activating software S4A. S4A
software can be downloaded from our Web site
M599 7020
7.1 Installation considerations
In order to maintain the accuracy stated in the technical data, the
sensor must be installed inline and fitted to tubes with the same
diameter.
• The sensor is for indoor use only! At an outdoor installation, the
sensor must be protected from solar radiation and rain.
• It is strongly recommend not to install S 418 permanently in wet
environment as it exists usually right after a compressor outlet.
12 S 418